Chucks and Sine Plates: Electromagnetic Chucks

You are here: Home | Chucks and Sine Plates | Electromagnetic Chucks

TRANSVERSE POLE CHUCK

The poles of this chuck run across the chuck from side to side. Pole spacing in the smaller chucks, up to 10" x 24", is generally 1/4" magnetic steel and 1/16" nonmagnetic stainless steel. Pole spacing of 1/4" magnetic and 1/8" nonmagnetic steel is used in the larger chucks

LONGITUDINAL POLE CHUCK

The poles of this chuck run the length of the chuck from end to end. Pole spacing up to 24" long is generally 1/4" magnetic steel and 1/16" nonmagnetic stainless steel. Pole spacing of 1/4" magnetic steel and 1/8" nonmagnetic stainless steel is used for larger chucks.
Top plates on both chucks are furnace brazed, making the magnetic and nonmagnetic steel into one solid, water tight unit.

To order Longitudinal and Transverse Chucks, please click here to see table below. Place an "L" in front of the model number for a longitudinal or long-bar chuck and a "T" for transverse or short-bar chuck. The A.C. input voltage and D.C. output voltage should be stated. The Model No. is also the size of the chuck.

MACHINING CHUCK

The Magnetool Extra Power electromagnetic machine chuck has a coil for each pole. The extra power makes this a good chuck for milling, shaping and heavy stock removal. It is made to order in practically any size required.

ORDERING INFORMATION

ELECTROMAGNETIC CHUCKS WITH RECTIFIER CONTROLLERS